ASTM-A276 › Historical Revision Information
Standard Specification for Stainless Steel Bars and Shapes
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers hot-finished or cold-finished bars except bars for reforging (Note 1). It includes rounds, squares, and hexagons, and hot-rolled or extruded shapes, such as angles, tees, and channels in the more commonly used types of stainless steels. The free-machining types (Note 2), for general corrosion resistance and high-temperature service, are covered in a separate specification.
Note 1—For bars for reforging, see Specification A 314.
Note 2—For free-machining stainless bars designed especially for optimum machinability, see Specification A 582/A 582M.
Note 3—There are standards covering high nickel, chromium, austenitic corrosion, and heat resisting alloy materials. These standards are under the jurisdiction of ASTM Subcommittee B 02.07 and may be found in Annual Book of ASTM Standards, Vol. 02.04.
1.2 The values stated in inch-pound units are to be regarded as the standard.
Keywords
austenitic stainless steel; austenitic-ferritic duplex stainless steel; ferritic stainless steel; martensitic stainless steel; stainless steel bars; stainless steel shapes
To find similar documents by ASTM Volume:
01.03 (Steel--Plate, Sheet, Strip, Wire; Stainless Steel Bar)
To find similar documents by classification:
77.140.60 (Steel bars and rods)
77.140.70 (Steel profiles Including sections)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A276-00a
Revision Level
2000A EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Sept. 10, 2000
Document Type
Specification
Page Count
7 pages
Committee Number
A01.17