Document Center is acquired by Nimonik

Scope

1.1 This specification covers hot-finished or cold-finished bars except bars for reforging (Note 1). It includes rounds, squares, and hexagons, and hot-rolled or extruded shapes, such as angles, tees, and channels in the more commonly used types of stainless steels. The free-machining types (Note 2), for general corrosion resistance and high-temperature service, are covered in a separate specification.

Note 1—For bars for reforging, see Specification A 314.

Note 2—For free-machining stainless bars designed especially for optimum machinability, see Specification A 582/A 582M.

Note 3—There are standards covering high nickel, chromium, austenitic corrosion, and heat resisting alloy materials. These standards are under the jurisdiction of ASTM Subcommittee B 02.07 and may be found in Annual Book of ASTM Standards, Vol. 02.04.

1.2 The values stated in inch-pound units are to be regarded as the standard.

Keywords

austenitic stainless steel; austenitic-ferritic duplex stainless steel; ferritic stainless steel; martensitic stainless steel; stainless steel bars; stainless steel shapes; ICS Number Code 77.140.20 (Steels of high quality); 77.140.60 (Steel bars and rods); 77.140.70 (Steel profiles)

To find similar documents by ASTM Volume:

01.03 (Steel--Plate, Sheet, Strip, Wire; Stainless Steel Bar)

To find similar documents by classification:

77.140.20 (Stainless steels Including alloyed steels, corrosion-resistant steels, heat-resisting steels, etc.)

77.140.60 (Steel bars and rods)

77.140.70 (Steel profiles Including sections)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.