ASTM-A334 › Standard Specification for Seamless and Welded Carbon and Alloy-Steel Tubes for Low-Temperature Service
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers several grades of minimum-wall-thickness, seamless and welded, carbon and alloy-steel tubes intended for use at low temperatures. Some product sizes may not be available under this specification because heavier wall thicknesses have an adverse affect on low-temperature impact properties.
1.2 Supplementary Requirement S1 of an optional nature is provided. This shall apply only when specified by the purchaser.
Note 1-For tubing smaller than 1/2 in. [12.7 mm] in outside diameter, the elongation values given for strip specimens in Table 1 shall apply. Mechanical property requirements do not apply to tubing smaller than 1/8 in. [3.2 mm] in outside diameter and with a wall thickness under 0.015 in. [0.4 mm].1.3 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. The inch-pound units shall apply unless the "M" designation of this specification is specified in the order.
Keywords
Alloy steel tube; Carbon steel tube; Low temperature service applications; emsteel; Welded steel tube; tubes; emcarbon/alloy steel, seamless/welded (for low-temperature; ICS Number Code 23.040.10 (Iron and steel pipes)
To find similar documents by ASTM Volume:
01.01 (Steel--Piping, Tubing, Fittings)
To find similar documents by classification:
23.040.10 (Iron and steel pipes Steel pipes and tubes for specific use, see 77.140.75)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-A480Standard Specification for General Requirements for Flat-Rolled Stainless and Heat-Resisting Steel Plate, Sheet, and Strip
UL-94
Standard for Tests for Flammability of Plastic Materials for Parts in Devices and Appliances
NFPA-13
Standard for the Installation of Sprinkler Systems
Document Number
ASTM-A0334_A0334M-04AR21
Revision Level
2004A R21 EDITION
Status
Current
Modification Type
Revision
Publication Date
Sept. 1, 2021
Document Type
Specification
Page Count
6 pages
Committee Number
A01.10