Document Center is acquired by Nimonik

Scope

1.1 This is an acceptance specification for the magnetic particle inspection of forged steel crankshafts having main bearing journals or crankpins 4 in. [200 mm] or larger in diameter.

1.2 There are three classes, with acceptance standards of increasing severity:

1.2.1 Class 1.

1.2.2 Class 2 (originally the sole acceptance standard of Specification A456).

1.2.3 Class 3 (formerly covered in Supplementary Requirement S1 of Specification A456-64 (1970)).

1.3 This specification is not written to cover diesel locomotive crankshafts specifically, but Class 2 or 3 may be applied if manufacturer and ultimate user agree to its use.

1.4 The values stated in either inches or SI (metric) units are to be regarded separately as the standard. Within the text and figures, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

1.5 Unless the order specifies the applicable "M" specification designation, the material shall be furnished to the inch units.

Keywords

Acceptance criteria/testing; Crankshafts; Railroad steel materials-forgings; Shipbuilding steel materials-crankshafts; Steel forgings-crankshaft; magnetic particle examination of large steel crankshaft forgings,; spec.,; Magnetic particle inspection; magnetic particle examination of large steel crankshaft forgings, spec; ICS Number Code 77.140.85 (Iron and steel forgings)

To find similar documents by ASTM Volume:

01.05 (Steel--Bars, Forgings, Bearing, Chain, Tool)

To find similar documents by classification:

77.140.85 (Iron and steel forgings)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.