ASTM-A463 Historical Revision Information
Standard Specification for Steel Sheet, Aluminum-Coated, by the Hot-Dip Process

ASTM-A463 - 1997 EDITION - SUPERSEDED -- See the following: ASTM-A463/A463M
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Specification for Steel Sheet, Aluminum-Coated, by the Hot-Dip Process
ORDER

Scope

1.1 This specification covers aluminum-coated steel sheet in coils and cut lengths available with two types of aluminum coating applied by the hot-dip process, with several coating weights [masses].

1.2 Product furnished under this specification shall conform to the applicable requirements of the latest issue of Specification A924/A924M, unless otherwise provided herein.

1.3 This specification is applicable to orders in either inch-pound units (as A463) or SI units [as A463M]. Values in inch-pound and SI units are not necessarily equivalent. Within the text, SI units are shown in brackets. Each system shall be used independently of the other.

1.4 Unless the order specifies the "M" designation (SI units), the product shall be furnished to inch-pound units.

1.5 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

aluminum-coated steel; coatings- aluminum; metallic coatings; steel sheet-aluminum coated; ICS Number Code 77.140.50 (Flat steel products and semi-products)

To find similar documents by ASTM Volume:

01.06 (Coated Steel Products)

To find similar documents by classification:

77.140.50 (Flat steel products and semi-products Including plate, sheet and strip Steel strips for springs, see 77.140.25)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-A463-97

Revision Level

1997 EDITION

Status

Superseded

Modification Type

Revision

Publication Date

April 10, 1997

Document Type

Specification

Page Count

5 pages

Committee Number

A05.11