ASTM-A573 Historical Revision Information
Standard Specification for Structural Carbon Steel Plates of Improved Toughness

ASTM-A573 - 1993A EDITION - SUPERSEDED -- See the following: ASTM-A573/A573M
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Specification for Structural Carbon Steel Plates of Improved Toughness
ORDER

Scope

1.1 This specification covers structural quality carbon-manganese-silicon steel plates in three tensile strength ranges intended primarily for service at atmospheric temperatures where improved notch toughness is important.

1.2 Plates covered by this specification are limited to a maximum thickness of 1.5 in. [40 mm].

1.3 When the steel is to be welded, it is presupposed that a welding procedure suitable for the grade of steel and intended use or service will be utilized. See Appendix X3 of Specification A6/A6M for information on weldability.

1.4 The values stated in either inch-pound units or SI units are to be regarded as the standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

Keywords

Carbon steel plate; Fusion welding; Steel plate-carbon steel; Steel plate-manganese alloy; Structural applications-steel; Carbon steel plate; Fusion welding; Steel plate-carbon steel; Steel plate-manganese alloy; Structural applications-steel; plates-C-Mn-Si steel, structural quality (for service with improved; notch toughness), spec; ICS Number Code 77.140.50 (Flat steel products and semi-products)

To find similar documents by ASTM Volume:

01.04 (Steel--Structural, Reinforcing, Pressure Vessel, Railway)

To find similar documents by classification:

77.140.50 (Flat steel products and semi-products Including plate, sheet and strip Steel strips for springs, see 77.140.25)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-A573-93a

Revision Level

1993A EDITION

Status

Superseded

Modification Type

Revision

Publication Date

Dec. 15, 1993

Document Type

Specification

Page Count

2 pages

Committee Number

A01.02