ASTM-A573 › Historical Revision Information
Standard Specification for Structural Carbon Steel Plates of Improved Toughness
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers structural quality carbon-manganese-silicon steel plates in three tensile strength ranges intended primarily for service at atmospheric temperatures where improved notch toughness is important. If the steel is to be welded, a welding procedure suitable for the grade of steel and intended use or service shall be utilized. The steel shall be made by fine grain practice. Heat and product analysis shall conform to the chemical composition requirements prescribed for carbon, manganese, phosphorus, sulfur, and silicon. The tension test specimen shall conform to the tensile requirements including tensile strength, yield point, and elongation.
Scope
1.1 This specification covers structural quality carbon-manganese-silicon steel plates in three tensile strength ranges intended primarily for service at atmospheric temperatures where improved notch toughness is important.
1.2 Plates covered by this specification are limited to a maximum thickness of 1.5 in. [40 mm].
1.3 If the steel is to be welded, it is presupposed that a welding procedure suitable for the grade of steel and intended use or service will be utilized. See Appendix X3 of Specification A6/A6M for information on weldability.
1.4 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system is to be used independently of the other without combining values in any way.
Keywords
carbon steel; plates; structural steel; toughness; welded construction; Basic-oxygen steel; Carbon steel plate--specifications; Fusion-welded materials/applications--specifications; Manganese alloy steel plate--specifications; Structural steel (SS) plate--specifications; ICS Number Code 77.140.50 (Flat steel products and semi-products)
To find similar documents by ASTM Volume:
01.04 (Steel--Structural, Reinforcing, Pressure Vessel, Railway)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A573/A573M-05(2009)
Revision Level
2005 R09 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Dec. 15, 2009
Document Type
Specification
Page Count
2 pages
Committee Number
A01.02