ASTM-A599 Historical Revision Information
Standard Specification for Tin Mill Products, Electrolytic Tin-Coated, Cold-Rolled Sheet

ASTM-A599 - 1999 EDITION - SUPERSEDED -- See the following: ASTM-A599/A599M
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Specification for Tin Mill Products, Electrolytic Tin-Coated, Cold-Rolled Sheet
ORDER

Scope

1.1 This specification covers cold-rolled steel sheet in coils or in cut lengths, tin-coated by electrodeposition. The product is commonly known as electrolytic tin-coated sheet, and is for applications that need good solderability, good surface appearance, and a degree of corrosion resistance. Tin-coated sheet is produced to various designations of tin coating, as outlined in Table 1.

1.1.1 Electrolytic tin-coated sheet is customarily available as commercial quality, drawing quality, drawing quality special killed, and structural quality which are fully described in Specifications A 366/A 366M, A 611, A 619/A 619M, and A 620/A 620M. The tin coating is available as unmelted or melted.

1.2 Limitations-This specification is applicable to orders in either inch-pound units (as A 599), which is supplied in thicknesses from 0.015 in. to 0.033 in., or SI units [as A 599M], which is supplied in thicknesses from 0.38 mm to 0.84 mm. For thicknesses lighter than 0.015 in. [0.38 mm], refer to A 624 [A 624M].

1.3 Unless the order shows the "M" designation [SI units], the product shall be furnished to inch-pound units. The values stated in either inch-pound or SI units are to be regarded as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with this specification.

Keywords

cold-rolled steel; steel sheet; coils; tin-coated; electrolytic tin-coated; electrodeposition

To find similar documents by ASTM Volume:

01.06 (Coated Steel Products)

To find similar documents by classification:

77.140.50 (Flat steel products and semi-products Including plate, sheet and strip Steel strips for springs, see 77.140.25)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-A599/A599M-99

Revision Level

1999 EDITION

Status

Superseded

Modification Type

Revision

Publication Date

Sept. 10, 1999

Document Type

Specification

Page Count

3 pages

Committee Number

A01.20