ASTM-A805 › Historical Revision Information
Standard Specification for Steel, Flat Wire, Carbon, Cold-Rolled
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers carbon steel flat wire in coils or cut lengths. Flat wire is classified as a cold-rolled section, rectangular in shape, 0.500 in. (12.7 mm) or less in width and under 0.250 in. (6.35 mm) in thickness.
1.2 Low-carbon steel flat wire is produced from steel compositions with a maximum carbon content of 0.25% by cast or heat analysis.
1.3 Carbon spring steel flat wire is produced to a carbon range in which the specified or required maximum is over 0.25% by cast or heat analysis.
1.3.1 Two types of carbon spring steel flat wire are produced:
1.3.1.1 Untempered cold-rolled carbon spring steel flat wire, produced to several desirable combinations of properties and
1.3.1.2 Hardened and tempered carbon spring steel wire.
1.4 Definite application flat wire is a product developed for a specific application and may be specified only by size and descriptive name.
Keywords
Steel wire-carbon steel; cold-rolled carbon steel flat wire, spec
To find similar documents by ASTM Volume:
01.03 (Steel--Plate, Sheet, Strip, Wire; Stainless Steel Bar)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A805
Revision Level
ADOPT WITHDRAWN
Status
Superseded
Modification Type
Reapproval
Publication Date
Aug. 4, 2009
Document Type
Specification
Page Count
1 page
Committee Number
A01.19