ASTM-A82 › Historical Revision Information
Standard Specification for Steel Wire, Plain, for Concrete Reinforcement
The following bibliographic material is provided to assist you with your purchasing decision:
1.1 This specification covers cold-drawn steel wire, as-drawn or galvanized, to be used as such, or in fabricated form, for the reinforcement of concrete, in sizes not less than 2.03 mm [0.080 in.] nominal diameter.
1.2 Supplement S1 describes high-strength wire, which shall be furnished when specifically ordered. It shall be permissible to furnish high-strength wire in place of regular wire if mutually agreed to by the purchaser and the manufacturer.
1.3 The values stated in either SI units or inch-pound units are to be regarded as standard. Within the text the inch-pound units are shown in brackets (except in Table 6). The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values may result in nonconformance with the specification.
concrete reinforcement; reinforced concrete; reinforcing steels; steel wire; ICS Number Code 77.140.15 (Steels for reinforcement of concrete)
To find similar documents by ASTM Volume:
To find similar documents by classification:
To find similar documents by Federal Supply Class Code:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Oct. 1, 2005