ASTM-A851 › Standard Specification for High-Frequency Induction Welded, Unannealed, Austenitic Steel Condenser Tubes (Withdrawn 2002)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers nominal-wall-thickness tubes intended for use as steam surface condenser tubes. These tubes are made from the austenitic steels listed in Table 1 using a high-frequency induction welding process where post-weld solution heat treatment is not necessary for corrosion resistance.
1.2 The tubing sizes and thickness usually furnished to this specification are 5/8 in. (15.9 mm) to 3 1/8 in. (79.4 mm) in outside diameter and 0.015 to 0.109 in. (0.40 to 2.8 mm), inclusive, in wall thickness. Tubing having other dimensions may be furnished, provided such tubes comply with all other requirements of this specification.
1.3 Optional supplementary requirements are provided in this specification and, when one or more of these are desired, each shall be so stated in the order.
1.4 The values stated in inch-pound units are to be regarded as the standard.
Keywords
Austenitic stainless steel tube; Condenser and heat exchanger systems; Welded steel tube; tubes; emaustenitic steel, high-frequency induction-welded (for steam; surface condenser tubes)
To find similar documents by ASTM Volume:
01.01 (Steel--Piping, Tubing, Fittings)
To find similar documents by classification:
23.040.10 (Iron and steel pipes Steel pipes and tubes for specific use, see 77.140.75)
This document comes with our free Notification Service, good for the life of the document.
This document is available in Paper format.
Document Number
ASTM-A851-96
Revision Level
1996 EDITION
Status
Superseded
Modification Type
Withdrawn
Publication Date
March 10, 1996
Document Type
Specification
Page Count
3 pages
Committee Number
A01.10