ASTM-A853 › Historical Revision Information
Standard Specification for Steel Wire, Carbon, for General Use
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers carbon steel wire coils for general use. Steel samples shall be hard drawn, annealed in process, or annealed at finish size. The steel shall either be ingot cast or strand cast. The carbon steel shall also undergo tensile tests and shall conform to the required values of tensile strength. Final products shall be marked either by a tag or bar code.
Scope
1.1 This specification covers carbon steel wire, supplied in coils, for general use. It may be produced hard drawn, annealed in process, or annealed at finish size.
1.2 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.
Keywords
annealed at finished size; annealed in process; carbon; hard drawn; wire; Carbon steel wire--specifications; ICS Number Code 77.140.65 (Steel wire, wir ropes and link chains)
To find similar documents by ASTM Volume:
01.03 (Steel--Plate, Sheet, Strip, Wire; Stainless Steel Bar)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A853-04(2010)
Revision Level
2004 R10 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
April 1, 2010
Document Type
Specification
Page Count
3 pages
Committee Number
A01.03