Document Center is acquired by Nimonik

Scope

1.1 This test method covers torsion (or twist) testing of metallic wire.

1.2 The values stated in U.S. Customary units are to be regarded as the standard. The SI equivalents of U.S. customary units may be approximate.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of whoever uses this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

torsion; metallic wire; twist testing

To find similar documents by ASTM Volume:

01.03 (Steel--Plate, Sheet, Strip, Wire; Stainless Steel Bar)

To find similar documents by classification:

77.140.65 (Steel wire, wire ropes and link chains Lifting link chains and wire ropes, see 53.020.30 Steel wire for springs, see 77.140.25)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.