ASTM-B100 › Standard Specification for Wrought Copper-Alloy Bearing and Expansion Plates and Sheets for Bridge and Other Structural Use
Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
Standard Specification for Wrought Copper-Alloy Bearing and Expansion Plates and Sheets for Bridge and Other Structural Use
Scope
1.1 This specification establishes the requirements for wrought copper-alloy bearing plate and bearing sheets for application in bridges and other structures. Specifically, the plates and sheets are to be used for fixed or expansion bearings where the motion is slow and intermittent with pressures not exceeding 3 ksi (20 Mpa).
1.2 The values stated in inch-pound units are the standard. Si values given in parentheses are for information only.
Keywords
bearing plates; bearing sheets; bridges; copper-alloy plates; copper-alloy sheets; expansion bearing plates; expansion bearing sheets; structures; ICS Number Code 77.150.30 (Copper products)
To find similar documents by ASTM Volume:
02.01 (Copper and Copper Alloys)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B0100-20
Revision Level
2020 EDITION
Status
Current
Modification Type
Revision
Publication Date
April 21, 2020
Document Type
Specification
Page Count
5 pages
Committee Number
B05.01