Document Center is acquired by Nimonik

Scope

1.1 This specification covers seamless tube and ferrule stock of copper and various copper alloys up to 79 mm, inclusive, in diameter, for use in surface condensers, evaporators, and heat exchangers. Tubes for this application are normally made from the following coppers or copper alloys:

Note 1--This specification is the metric companion to Specification B111.

Note 2--Warning: Mercury is a definite health hazard in use and disposal. (See 12.1.)

1.2 The following safety hazards caveat pertains only to the test methods portion, Section 18, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

aluminum bronzes; brass-pipe/tube; bronze-pipe/tube; condenser and heat exchanger systems-copper/copper alloy; copper-tube; copper-tube (seamless); copper alloy tube-seamless; evaporation; seamless copper/copper alloy tube; surface condensers; seamless condenser tubes/ferrule stock (Cu/Cu-alloy), for surface; condensers/evaporators/heat exchangers; ICS Number Code 77.150.30 (Copper products)

To find similar documents by ASTM Volume:

02.01 (Copper and Copper Alloys)

To find similar documents by classification:

77.150.30 (Copper products)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.