ASTM-B116 › Standard Specification for Figure-9 Deep-Grooved and Figure-8 Copper Trolley Wire for Industrial Haulage
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
This specification deals with figure-9 deep-section grooved and figure-8 copper trolley wire for use in industrial haulage. The material shall conform to the required tensile properties: tensile strength and elongation. Tension tests shall be made. However, elongation tests shall not be made on specimens containing joints. The electrical resistivity shall be determined by resistance measurements. The standard sizes of figure-9 deep-section grooved and figure-8 copper trolley wire are specified.
1.1 This specification covers figure-9 deep-section grooved and figure-8 copper trolley wire for use in industrial haulage (Explanatory ).
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ICS Number Code 29.060.10 (Wires); 29.280 (Electric traction equipment)
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
1995 R17 EDITION
April 15, 2017