ASTM-B117 › Historical Revision Information
Standard Practice for Operating Salt Spray (Fog) Apparatus
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice describes the apparatus, procedure, and conditions required to create and maintain the salt spray (fog) test environment. Suitable apparatus which may be used is described in Appendix X1.
1.2 This practice does not prescribe the type of test specimen or exposure periods to be used for a specific product, nor the interpretation to be given to the results.
1.3 The values stated in SI units are to be regarded as standard. The inch-pound units in parentheses are provided for information and may be approximate.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
controlled corrosive environment; corrosive conditions; determining mass loss; salt spray (fog) exposure; ICS Number Code 49.025.05 (Ferrous alloys in general); 49.025.15 (Non-ferrous alloys in general)
To find similar documents by ASTM Volume:
03.02 (Corrosion of Metals; Wear and Erosion)
To find similar documents by classification:
77.060 (Corrosion of metals Surface treatment and coating, see 25.220)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B117-97
Revision Level
1997 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
April 10, 1997
Document Type
Practice
Page Count
8 pages
Committee Number
G01.05