ASTM-B164 › Standard Specification for Nickel-Copper Alloy Rod, Bar, and Wire
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers nickel-copper alloys UNS N04400 and N04405 in the form of hot-worked and cold-worked rod, bar, and wire. The material shall conform to the chemical composition limits specified by the reference material. The materials for rod, bar, or wire shall conform to the mechanical properties specified by the reference material. One test per lot shall be performed for chemical analysis, tension test, hardness test, and wrapping test.
Scope
1.1 This specification2 covers nickel-copper alloys UNS N04400 and N044053 in the form of hot-worked and cold-worked rod and bar in the conditions shown in Table 1 and cold-worked wire in the conditions shown in Table 2.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Keywords
bar; rod; wire; N04400;; ICS Number Code 77.150.40 (Nickel and chromium products)
To find similar documents by ASTM Volume:
To find similar documents by classification:
77.150.40 (Nickel and chromium products)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-A240Standard Specification for Chromium and Chromium-Nickel Stainless Steel Plate, Sheet, and Strip for Pressure Vessels and for General Applications
ASTM-A276
Standard Specification for Stainless Steel Bars and Shapes
ASTM-A484
Standard Specification for General Requirements for Stainless Steel Bars, Billets, and Forgings
Document Number
ASTM-B164-03(2019)
Revision Level
2003 R19 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
May 1, 2019
Document Type
Specification
Page Count
9 pages
Committee Number
B02.07