ASTM-B200 › Historical Revision Information
Standard Specification for Electrodeposited Coatings of Lead and Lead-Tin Alloys on Steel and Ferrous Alloys
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers the requirements for electrodeposited coatings of lead and lead-tin alloys on steel and ferrous alloys. The coatings of lead-tin alloys are those that range in tin content up to but not exceeding 15 mass%. The coatings ranging between 3 and 15 mass% in tin content are known also as "terne" metallic electrodeposits.
1.2 This specification does not apply to sheet, strip, or wire in the unfabricated form.
1.3 The following precautionary caveat pertains only to the test method portion, Section 11, of this specification: This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
electrodeposited coatings, lead and lead-tin alloys; lead/lead-tin alloy on steel/ferrous alloys; ICS Number Code 25.220.40 (Metallic coatings)
To find similar documents by ASTM Volume:
02.05 (Metallic and Inorganic Coatings; Metal Powders and Metal Powder Products)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B200-85(1999)
Revision Level
1985 R99 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
March 29, 1985
Document Type
Specification
Page Count
6 pages
Committee Number
B08.06