Document Center is acquired by Nimonik

Scope

1.1 This specification establishes a group of general requirements common to wrought copper and copper alloy rod, bar, shapes and forgings which shall apply to Specifications B16M, B21M, B98M, B124M, B133M, B138M, B139M, B140M, B150M, B151M, B196M, B283, B301M, and B455M to the extent referenced therein.

1.2 The chemical composition, physical and mechanical properties, and all other requirements not included in this specification shall be prescribed in the product specification.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4 This specification is the SI companion of Specification B249.

1.5 SI units are the measurement standard.

Note 1-Requirements for flat wire (defined as flat products up to and including 4.8 mm in thickness and up to 80 mm in width with all surfaces rolled or drawn without having been slit, sheared, or sawed) including square, furnished in coils or straight lengths, or on spools, reels, or bucks are described by wire Specifications B206M and B272.

Keywords

Carbon content; Combustion; Infrared (IR) analysis; Sulfur content; carbon/sulfur in wrought Cu/Cu-alloy rod/bar/shapes, by; combustion/infrared analysis, test,; Copper-rod/bar/shapes; Copper alloy rod/bar/shapes; General delivery requirements-Cu/Cu-alloy; rod/bar/shapes (wrought Cu/Cu alloy), general requirements, spec., (for; metric see B 249M),; Terminology-Cu/Cu alloy; Wrought Cu/Cu-alloy materials/applications; wrought Cu/Cu-alloy rod/bar/shapes, terminology, spec

To find similar documents by ASTM Volume:

02.01 (Copper and Copper Alloys)

To find similar documents by classification:

77.150.30 (Copper products)

This document comes with our free Notification Service, good for the life of the document.

This document is available in Paper format.