ASTM-B30 › Historical Revision Information
Standard Specification for Copper Alloys in Ingot Form
The following bibliographic material is provided to assist you with your purchasing decision:
This specification establishes the requirements for copper alloys in ingot form that shall be subjected to remelting for the manufacture of castings having the Copper Alloy UNS No. designations specified and enumerated herein. Any material and manufacturing process may be used so long as the alloy is of the required composition and mechanical characteristics, and the yielded ingot is free of defects of a kind that would render it unsuitable for remelting. Materials shall hence be sampled, prepared, and tested accordingly to examine their conformance to mechanical, chemical composition, and weldability requirements.
Scope
1.1 This specification establishes the requirements for copper alloys in ingot form for remelting for the manufacturing of castings having the Copper Alloy UNS No. designation, commercial designations and nominal composition shown in Table 1 and Table 2.
1.2 A cross reference of Copper Alloy UNS Nos. and copper alloy casting specifications is given in Table 3.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
Keywords
copper alloy; copper alloy castings; copper-base alloys; copper-base alloy castings; ingot; ICS Number Code 77.150.30 (Copper products)
To find similar documents by ASTM Volume:
02.01 (Copper and Copper Alloys)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B30-12
Revision Level
2012 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Sept. 15, 2012
Document Type
Specification
Page Count
14 pages
Committee Number
B05.05