ASTM-B37 Standard Specification for Aluminum for Use in Iron and Steel Manufacture

ASTM-B37 - 2018 EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This specification covers the standard for ingot, bar, rod, cone, nugget or shot aluminum and aluminum alloys proposed for use in manufacturing iron and steel. Each sample shall conform to the chemical composition limits enlisted herein. Test samples can be taken at the time the ingots, bars, rods, cones, nuggets or shots are produced or from the finished product.

ORDER

Price:

$55.00        


Want this as a site license?

Changes from the previous issue

A redline edition is available for this document, with all changes visible. Ask Document Center Inc. for more information.

Scope

1.1 This specification covers aluminum-alloy deoxidizing products of all compositions in the form of ingots, bars, rods, cones, nuggets, shot, or stars, for use in the manufacture of iron and steel. Six of the most commonly used deoxidizing product compositions are designated as shown in Table 1.

(A) Analysis shall be made only for copper, zinc, magnesium, silicon, and iron unless the determination of additional elements is required by the contract or order, or the presence of other elements in substantial concentration is indicated during the course of the analysis. In the latter case, the amount of these other elements shall be determined, reported, and the total of copper, zinc, magnesium, silicon, iron, and “other elements” shall not exceed the specified amount prescribed in the last column of the table. Unless otherwise specified in the contract or order, 0.2 % or more of any “other element” shall constitute a “substantial concentration” and require that element to be reported.
(B) The following applies to all specified limits in this table: For purposes of determining conformance to these limits, an observed value or a calculated value obtained from analysis shall be rounded to the nearest unit in the last right-hand place of figures used in expressing the specified limit in accordance with the rounding-off method of Practice E29.

1.2 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

aluminum; deox; deoxidizing; iron manufacture; steel manufacture;; ICS Number Code 77.120.10 (Aluminium and aluminium alloys)

To find similar documents by ASTM Volume:

02.02 (Aluminum and Magnesium Alloys)

To find similar documents by classification:

77.120.10 (Aluminium and aluminium alloys)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-B37-18

Revision Level

2018 EDITION

Status

Current

Modification Type

Revision

Publication Date

May 1, 2018

Document Type

Specification

Page Count

4 pages

Committee Number

B07.01