ASTM-B481 › Historical Revision Information
Standard Practice for Preparation of Titanium and Titanium Alloys for Electroplating
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice describes processes that have been found to be successful in producing adherent electrodeposits of good quality on titanium and certain titanium alloys. Not all of the processes that have been reported as successful are described, but rather three basic ones that have had the widest use. A rather complete listing of the published work on electroplating on titanium is given in the list of references which appear at the end of this practice.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see 3.1.
Keywords
titanium; titanium alloys; electroplating; electrodeposits; ICS Number Code 77.150.50 (Titanium products)
To find similar documents by ASTM Volume:
02.05 (Metallic and Inorganic Coatings; Metal Powders and Metal Powder Products)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B481-68(2003)e1
Revision Level
1968 R03(E1) EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
May 1, 2003
Document Type
Practice
Page Count
3 pages
Committee Number
B08.02