Document Center is acquired by Nimonik

Scope

1.1 This specification covers aluminum-alloy 5005 Drawing stock, 0.375 in. (9.52 mm) in diameter, in the tempers shown in Table 1, for drawing into wire for electrical conductors (Explanatory Notes 1 and 2).

1.2 The SI values for density and resistivity are regarded as the standard. For all other properties the inch-pound values are to be regarded as standard and the SI units may be approximate.

Note 1-The alloy and temper designations conform to ANSI H35.1. Aluminum-alloy 5005 corresponds to unified numbering system alloy A95005 in accordance with Practice E527.

Keywords

aluminum drawing stock; aluminum-alloy 5005 drawing stock; aluminum-alloy drawing stock; drawing stock for aluminum wire

To find similar documents by ASTM Volume:

02.03 (Electrical Conductors)

To find similar documents by classification:

77.150.10 (Aluminium products)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.