ASTM-B532 Standard Specification for Appearance of Electroplated Plastic Surfaces

ASTM-B532 - 1985 R14 EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This specification limits the amounts and types of visual defects that can be tolerated on decoratively electroplated surfaces of plastic products. The appearance of surfaces will be separately evaluated depending on the prominence of the surface under conditions of ordinary use. The classifications are: surface A; surface B; and surface C. The part under test shall be evaluated in the same relative position as it will normally be viewed under usual conditions of use.

ORDER

Price:

$44.00        

Scope

1.1 This specification limits the amounts and types of visual defects that can be tolerated on decoratively electroplated surfaces of plastic products. The quantity of defects permitted shall be specified by the purchaser.

Significance and Use

5.1 Where electroplated plastics are used for decorative purposes, the appearance after plating is important. This standard provides a means of evaluating the appearance of the substrate and the coating.

Keywords

appearance; electroplated plastic

To find similar documents by ASTM Volume:

02.05 (Metallic and Inorganic Coatings; Metal Powders and Metal Powder Products)

To find similar documents by classification:

25.220.40 (Metallic coatings Including electrolytic depositions, cathodic coatings, autocatalytic coatings, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-B532-85(2014)

Revision Level

1985 R14 EDITION

Status

Current

Modification Type

Reapproval

Publication Date

June 1, 2014

Document Type

Specification

Page Count

2 pages

Committee Number

B08.05