ASTM-B753 › Standard Specification for Thermostat Component Alloys
The following bibliographic material is provided to assist you with your purchasing decision:
This specification details the requirements for alloys to be used as components in the manufacture of bonded multi-component thermostat metal strip. It describes alloys having composition, and thermal expansion suitable for application in thermostat metal sheet and strip. The material shall be free of scale, slivers, cracks, seams, corrosion and other defects as best commercial practice will permit. Surfaces shall be uniform and sufficiently clean. Product surface condition can be agreed upon between supplier and purchaser since surface condition can vary for different alloys and because bonding practices vary. The material shall be made of carbon, manganese, silicon, phosphorus, sulfur, chromium, nickel, copper, aluminum, cobalt, and iron. This product shall be supplied in the condition agreed upon by purchaser and seller. Hardness shall be measured on representative samples from each heat treat lot.
Scope
1.1 This specification describes requirements for alloys to be used as components in the manufacture of bonded multi-component thermostat metal strip. More specifically it describes alloys having composition, and thermal expansion suitable for application in thermostat metal sheet and strip.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Safety Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety, health, and environmental practices, and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Keywords
alloys; chemical composition; components; controlled thermal expansion; electrical resistivity; hardness; temper; thermostat metal strip;; ICS Number Code 77.120.01 (Non-ferrous metals in general)
To find similar documents by ASTM Volume:
To find similar documents by classification:
77.120.01 (Non-ferrous metals in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-A240Standard Specification for Chromium and Chromium-Nickel Stainless Steel Plate, Sheet, and Strip for Pressure Vessels and for General Applications
ASTM-A484
Standard Specification for General Requirements for Stainless Steel Bars, Billets, and Forgings
ASTM-E1316
Standard Terminology for <?Pub Dtl?>Nondestructive Examinations
Document Number
ASTM-B753-07(2018)
Revision Level
2007 R18 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
Nov. 1, 2018
Document Type
Specification
Page Count
4 pages
Committee Number
B02.10