Document Center is acquired by Nimonik

Scope

1.1 This test method covers a procedure for measuring the flow characteristics of a given volume of powder.

1.2 The values stated in SI units are to be regarded as the standard (except for the Hall Flowmeter Funnel, which is produced in inch-pound units). The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

Arnold/Hall flow; Flow and flow rate-metal powders; Metal powders; Volumetric flow; volumetric flow rate-metal powders, using Arnold meter/Hall funnel,; test,; Hall funnel; volumetric flow rate-metal powders, using Arnold meter/Hallfunnel,; test,; Interparticle friction; volumetric flow rate-metal powders, using Arnoldmeter/Hall funnel,; test,;Order Form; ICS Number Code 17.120.01 (Measurement of fluid flow in general)

To find similar documents by ASTM Volume:

02.05 (Metallic and Inorganic Coatings; Metal Powders and Metal Powder Products)

To find similar documents by classification:

17.120.01 (Measurement of fluid flow in general)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.