ASTM-B916 › Historical Revision Information
Standard Test Method for Adherence of Porcelain Enamel Coatings to Sheet Metal
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 The scope of this test method is:
1.1.1 To determine quantitatively the amount of enamel remaining after the porcelain enamel coating specimen has been deformed;
1.1.2 To standardize the deformation parameters for testing adherence of porcelain enamel to sheet metal; and,
1.1.3 To provide a quantitative adherence rating scale for comparison to reference standards.
1.2 This adherence test method is applicable to porcelain enamel coatings on substrates from 18 to 24 gage (0.0478 to 0.025 in. or from 1.214 to 0.654 mm).
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
adherence; porcelain enamel coatings; sheet metal; ICS Number Code 25.220.50 (Enamels)
To find similar documents by ASTM Volume:
02.05 (Metallic and Inorganic Coatings; Metal Powders and Metal Powder Products)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B916-01
Revision Level
2001 EDITION
Status
Superseded
Modification Type
New
Publication Date
March 10, 2001
Document Type
Test Method
Page Count
5 pages
Committee Number
B08.12