ASTM-B963 Historical Revision Information
Standard Test Methods for Oil Content, Oil-Impregnation Efficiency, and Surface-Connected Porosity of Sintered Powder Metallurgy (PM) Products Using Archimedes’ Principle

ASTM-B963 - DOD ADOPTION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Methods for Oil Content, Oil-Impregnation Efficiency, and Surface-Connected Porosity of Sintered Powder Metallurgy (PM) Products Using Archimedes’ Principle
ORDER

Scope

1.1 This standard describes three related test methods that cover the measurement of physical properties of oil-impregnated powder metallurgy products.

1.1.1 Determination of the volume percent of oil contained in the material.

1.1.2 Determination of the efficiency of the oil-impregnation process.

1.1.3 Determination of the percent interconnected porosity by oil impregnation.

1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are converted in accordance with IEEE/ASTM SI 10 and are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

Oil content values are generally contained in specifications for oil-impregnated PM bearings.

The oil-impregnation efficiency provides an indication of how well the as-received parts had been impregnated.

The desired self-lubricating performance of PM bearings requires a minimum amount of interconnected porosity and satisfactory oil impregnation of the interconnected porosity. A minimum oil content is specified.

The results from these test methods may be used for quality control or compliance purposes.

Keywords

mpregnation efficiency; interconnected porosity; oil content; oil-impregnated bearings; oil-impregnation efficiency; oil-impregnated PM parts; ICS Number Code 77.160 (Powder metallurgy)

To find similar documents by ASTM Volume:

02.05 (Metallic and Inorganic Coatings; Metal Powders and Metal Powder Products)

To find similar documents by classification:

77.160 (Powder metallurgy Including sintered metal materials and hardmetals)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-B963

Revision Level

DOD ADOPTION

Status

Superseded

Modification Type

New

Publication Date

Feb. 17, 2009

Document Type

Test Method

Page Count

1 page

Committee Number

B09.04