ASTM-C113 › Standard Test Method for Reheat Change of Refractory Brick
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of the permanent linear change of refractory brick when heated under prescribed conditions.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
Note 1-Test methods incorporating additional provisions pertinent to specific refractory materials are given in the following Test Methods: C179, C210, C436, and C605.1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
Heating tests-refractories; Linear changes/linearity; Refractories (brick and shapes); reheat change of refractory brick, test; ICS Number Code 81.080 (Refractories)
To find similar documents by ASTM Volume:
15.01 (Refractories, Activated Carbon; Advanced Ceramics)
To find similar documents by classification:
81.080 (Refractories Including ceramic refractories)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C0113-14R19
Revision Level
2014 R19 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
Nov. 1, 2019
Document Type
Test Method
Page Count
3 pages
Committee Number
C08.02