ASTM-C1150 Standard Test Method for the Break-Off Number of Concrete (Withdrawn 2002)

ASTM-C1150 - 1996 EDITION - CANCELLED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for the Break-Off Number of Concrete (Withdrawn 2002)

Scope

1.1 This test method covers determination of the break-off number of hardened concrete in test specimens or structures, by measuring the force required to cause failure of a pre-cast or drilled core specimen loaded as a cantilever.

1.2 The values stated in SI units are to be regarded as the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

Break-off number; Concrete-hardened; Failure end point; break-off number of concrete (in test specimens/structures); ICS Number Code 91.100.30 (Concrete and concrete products)

To find similar documents by ASTM Volume:

04.02 (Concrete and Aggregates)

To find similar documents by classification:

91.100.30 (Concrete and concrete products Including admixtures)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-C1150-96

Revision Level

1996 EDITION

Status

Cancelled

Modification Type

Withdrawn

Publication Date

May 10, 1996

Document Type

Test Method

Page Count

4 pages

Committee Number

C09.64