ASTM-C1190 › Standard Practice for Location of Test Specimens from Magnesia-Carbon and Impregnated Burned Basic Brick
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice covers a procedure for preparing test specimens from magnesia-carbon and impregnated burned basic brick. This practice generally concerns preparation of test specimens from brick greater than 13 in. (33 cm) in length. These brick are mainly manufactured for use in electric arc furnaces and basic oxygen furnaces.
1.2 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
impregnated burned brick; magnesia-carbon; pitch-bearing brick; refractories; resin-bonded brick; specimen operation; ICS Number Code 91.100.15 (Mineral materials and products)
To find similar documents by ASTM Volume:
15.01 (Refractories, Activated Carbon; Advanced Ceramics)
To find similar documents by classification:
91.100.15 (Mineral materials and products Including earth, sands, clay, slates, stones, etc.)
91.100.25 (Terracotta building products Including roofing tiles, bricks, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C1190-18R22
Revision Level
2018 R22 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
Sept. 26, 2022
Document Type
Practice
Page Count
3 pages
Committee Number
C08.92