ASTM-C1352 › Standard Test Method for Flexural Modulus of Elasticity of Dimension Stone
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the procedure for determining the flexural modulus of elasticity of stone by using a simple beam with quarter-point loading.
1.2 Stone tests may be made with load applied perpendicular to the bedding plane or rift and with load applied parallel to the bedding plane or rift.
1.3 Stone tests may be made for wet and dry specimen conditions.
1.4 The specifier of the test shall determine which conditions shall be used.
1.5 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
dimension stone; flexure; modulus of elasticity; stone
To find similar documents by ASTM Volume:
04.07 (Building Seals and Sealants; Fire Standards; Dimension Stone)
To find similar documents by classification:
91.100.15 (Mineral materials and products Including earth, sands, clay, slates, stones, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C1352_C1352M-21
Revision Level
2021 EDITION
Status
Current
Modification Type
New
Publication Date
Sept. 1, 2021
Document Type
Test Method
Page Count
4 pages
Committee Number
C18.01