Document Center is acquired by Nimonik

Scope

1.1 This test method covers the approximate determination of clay lumps and friable particles in aggregates.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

Note 1—Sieve sizes openings are identified by their Specification E11 designation with their alternative Specification E11 designation given in parentheses for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

This test method is of primary significance in determining the acceptability of aggregate with respect to the requirements of Specification C33.

Keywords

aggregates; clay lumps; friable particles; Aggregate; Clay lumps/particles; Friable particles content; Mineral aggregate; ICS Number Code 91.100.01 (Construction materials); 91.100.30 (Concrete and concrete products)

To find similar documents by ASTM Volume:

04.02 (Concrete and Aggregates)

To find similar documents by classification:

91.100.01 (Construction materials in general)

91.100.30 (Concrete and concrete products Including admixtures)

To find similar documents by Federal Supply Class Code:

FSC 5610 (Mineral Construction Materials, Bulk)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.