ASTM-C1467 › Standard Specification for the Installation of Molded Glass Fiber Reinforced Gypsum Parts
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers the installation of molded glass fiber reinforced gypsum (GRG) parts. Molded glass fiber reinforced gypsum parts shall conform to environment conditions, substrate preparation, installation, and finishing requirements specified.
Scope
1.1 This specification covers the installation of molded glass fiber reinforced gypsum (GRG) parts.
1.2 The values stated in either inch-pound units or SI (metric) are to be regarded separately as the standard. Within the text, SI units are shown in brackets. The values stated in each shall be used independent of the other. Values from the two systems shall not be combined.
1.3 All references to finishes, dimensions and tolerances shall refer to the finished surface of the part.
1.4 The text of this standard references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.
Keywords
GRG parts; installation; ICS Number Code 81.040.20 (Glass in building)
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C1467_C1467M-00R21
Revision Level
2000 R21 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
May 7, 2021
Document Type
Specification
Page Count
2 pages
Committee Number
C11.03