ASTM-C302 › Standard Test Method for Density and Dimensions of Preformed Pipe-Covering-Type Thermal Insulation
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of the dimensions and density, after conditioning, of preformed pipe insulation.
1.1.1 Procedure 1 is applicable to sections of one-piece pipe covering or to sections of segmental pipe covering that can be joined together concentrically and measured as one-piece.
1.1.2 Procedure 2 is applicable to segmental pipe covering where each section of material is measured.
1.1.3 Procedure 3 is applicable to sections of one-piece pipe covering, such as soft foam or mineral wool materials, where it is possible to penetrate the material.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
Density-thermal insulating materials; preformed pipe-type insulation, test,; Pipe thermal insulation; preformed insulation, density determination, test
To find similar documents by ASTM Volume:
04.06 (Thermal Insulation; Building and Environmental Acoustics)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C0302-13R22
Revision Level
2013 R22 EDITION
Status
Current
Modification Type
Revision
Publication Date
June 28, 2022
Document Type
Test Method
Page Count
3 pages
Committee Number
C16.32