ASTM-C426 › Historical Revision Information
Standard Test Method for Linear Drying Shrinkage of Concrete Masonry Units
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers a routine standardized procedure for determining the linear drying shrinkage of concrete masonry units or related concrete units under specified accelerated drying conditions.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
This test method is intended to evaluate the drying shrinkage characteristics of a given unit. The results of this laboratory method are considered in determining concrete masonry crack control provisions.
Note 1—The testing laboratory performing this test method should be evaluated in accordance with Practice C1093.
Keywords
comparator; concrete brick; concrete masonry units; drying; drying oven; shrinkage; strain gauge; ICS Number Code 91.100.30 (Concrete and concrete products)
To find similar documents by ASTM Volume:
To find similar documents by classification:
91.100.30 (Concrete and concrete products Including admixtures)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C426-10
Revision Level
2010 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Dec. 1, 2010
Document Type
Test Method
Page Count
6 pages
Committee Number
C15.03