ASTM-C457 Historical Revision Information
Standard Test Method for Microscopical Determination of Parameters of the Air-Void System in Hardened Concrete

ASTM-C457 - 1982A(E1) EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Microscopical Determination of Parameters of the Air-Void System in Hardened Concrete
ORDER

Scope

1.1 This test method describes procedures for microscopical determinations of the air content of hardened concrete and of the specific surface, void frequency, spacing factor, and paste-air ratio of the air-void system in hardened concrete (1). Two procedures are described:

1.1.1 Procedure A , the linear-traverse method (2, 3).

1.1.2 Procedure B , the modified point-count method (3, 4, 5, 6).

1.2 This test method is based on prescribed procedures that are applied to sawed and lapped sections of specimens of concrete from the field or laboratory.

1.3 It is intended to outline the principles of this test method and to establish standards for its adequate performance but not to describe in detail all the possible variations that might be used to accomplish the objectives of this test method.

1.4 The values stated in inch-pound units are to be regarded as the standard.

1.5 This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements see Notes 3 and 6.

Keywords

Air content; Air voids; Concrete-air content; Concrete-hardened; Linear traverse (Rosiwal) method; Microscopic examination-concrete; Modified point-count method; Petrographic analysis; Pore structure; air-void content/parameters of air-void system in hardened concrete, by; microscopical determination, test,; Spacing factor; Surface analysis-concrete; air-void content (in hardened concrete), test; ICS Number Code 91.100.30 (Concrete and concrete products)

To find similar documents by ASTM Volume:

04.02 (Concrete and Aggregates)

To find similar documents by classification:

91.100.30 (Concrete and concrete products Including admixtures)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-C457-82ae1

Revision Level

1982A(E1) EDITION

Status

Superseded

Modification Type

Revision

Publication Date

April 1, 1990

Document Type

Test Method

Page Count

11 pages

Committee Number

C09.65