ASTM-C585 › Standard Practice for Inner and Outer Diameters of Thermal Insulation for Nominal Sizes of Pipe and Tubing
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice is intended as a dimensional standard for preformed rigid thermal insulation for pipes and tubing.
1.2 This practice covers insulation supplied in cylindrical sections, usually split into half-sections, and lists recommended inner and outer diameters of insulation having nominal wall thicknesses from 1 to 5 in. (25 to 127 mm) to fit over standard sizes of pipe and tubing.
1.3 This standard does not purport to address the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.4 The values stated in inch-pound units are to be regarded as the standard. The values stated in SI units are provided for information only.
Keywords
Diameter; Insulated flat surfaces/pipes; Pipe thermal insulation; Thermal insulating materials-pipe; Thermal insulating materials-rigid; inner/outer diameters of rigid thermal insulation for nominal sizes of; pipe/tubing, NBS system, practice; ICS Number Code 27.220 (Heat recovery. Thermal insulation)
To find similar documents by ASTM Volume:
04.06 (Thermal Insulation; Building and Environmental Acoustics)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C0585-22
Revision Level
2022 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
June 13, 2022
Document Type
Practice
Page Count
10 pages
Committee Number
C16.20