ASTM-C610 › Historical Revision Information
Standard Specification for Molded Expanded Perlite Block and Pipe Thermal Insulation
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers molded expanded perlite block, fittings, and pipe thermal insulation intended for use on surfaces with temperatures of certain range. The insulation shall not have visible defects that will adversely affect its service qualities. Different test methods shall be performed in order to determine the properties of the block, fitting, and pipe insulations: density, apparent thermal conductivity, linear shrinkage after heat soaking, flexural strength, compressive strength, weight loss by tumbling, moisture content, water absorption after heat aging, surface bearing characteristics, hot-surface performance, and stress corrosion cracking of austenitic stainless steel.
Scope
1.1 This specification covers molded expanded perlite block, fittings, and pipe thermal insulation intended for use on surfaces with temperatures between 80 to 1200°F (27 to 649°C).
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
Keywords
block; expanded perlite; fittings; molded; pipe; thermal insulation; ICS Number Code 91.100.60 (Thermal and sound insulating materials)
To find similar documents by ASTM Volume:
04.06 (Thermal Insulation; Building and Environmental Acoustics)
To find similar documents by classification:
91.100.60 (Thermal and sound insulating materials)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C610-07
Revision Level
2007 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
April 15, 2007
Document Type
Specification
Page Count
5 pages
Committee Number
C16.20