ASTM-C632 › Historical Revision Information
Standard Test Method for Reboiling Tendency of Sheet Steel for Porcelain Enameling
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
1.1 This test method covers the determination of whether a sheet steel for porcelain enameling will reboil under a given set of worse case conditions.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
The results of this test indicate whether or not a sheet steel will cause reboiling under one given set of enameling conditions and enable the enamel processor to establish a possible source of imperfections in the finished coating.
This test method is normally used to test samples from lots, coils, or lifts of sheet steel which for some reason, production problems, defects evident on enameled parts, or production experience are suspected of causing defects in enameled ware which have the appearance of reboiling. It is often used to establish whether a problem exists with the bare steel or other factors such as the porcelain enamel, processing contamination, and so forth.
porcelain enamel products; reboiling tendency; reboiling tendency of sheet steel for porcelain enameling; ICS Number Code 25.220.50 (Enamels)
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
1988 R11(E1) EDITION
Reapproval with Ed Change
April 1, 2011