ASTM-C661 › Historical Revision Information
Standard Test Method for Indentation Hardness of Elastomeric-Type Sealants by Means of a Durometer
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method describes a laboratory procedure for determining indentation hardness of joint sealing compounds, (single- and multicomponent), intended for use in building construction.
1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.
1.3 This standard does not purport to address the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
elastomeric sealant; hardness; ICS Number Code 83.060 (Rubber); 91.100.50 (Binders. Sealing materials)
To find similar documents by ASTM Volume:
04.07 (Building Seals and Sealants; Fire Standards; Dimension Stone)
To find similar documents by classification:
83.060 (Rubber Raw rubber, see 83.040.10)
91.100.50 (Binders. Sealing materials Including geomembranes, asphalts for buildings, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C661-98
Revision Level
1998 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
May 10, 1998
Document Type
Test Method
Page Count
3 pages
Committee Number
C24.20