ASTM-C973 › Standard Practice for Preparing Test Specimens From Basic Refractory Gunning Products by Pressing
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice covers a procedure for preparing test specimens from basic refractory gunning products by pressing prepared material in a mold. After pressing, test specimens prepared from dolomitic mixes are subjected to a prescribed heat treatment. Specimens prepared in accordance with this procedure are intended for use in ASTM test methods.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
Refractories (general)-preparing test specimens; from refractory gunning products, by pressing, practice,; Specimen preparation (for testing)-refractory concrete; refractory gunning products, by pressing, practice; ICS Number Code 81.080 (Refractories)
To find similar documents by ASTM Volume:
15.01 (Refractories, Activated Carbon; Advanced Ceramics)
To find similar documents by classification:
81.080 (Refractories Including ceramic refractories)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C0973-87R20
Revision Level
1987 R20 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
Nov. 9, 2020
Document Type
Practice
Page Count
2 pages
Committee Number
C08.09