ASTM-D1016 Standard Test Method for Purity of Hydrocarbons from Freezing Points (Withdrawn 2019)

ASTM-D1016 - 2005 R15 EDITION - SUPERSEDED -- See the following: ASTM-D940
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Purity of Hydrocarbons from Freezing Points (Withdrawn 2019)

Scope

1.1 This test method covers the sampling and determination of purity of essentially pure compounds for which the freezing points for zero impurity and cryoscopic constants are given.2 The compounds to which the test method is applicable are: (Warning—Extremely flammable liquids and liquefied gases.)

n-butane

1,3-butadiene

isobutane

isoprene(2-methyl-1,3-butadiene)

n-pentane

benzene

isopentane

toluene (methylbenzene)

n-hexane

ethylbenzene

n-heptane

o-xylene (1,2-dimethylbenzene)

n-octane

m-xylene (1,3-dimethylbenzene)

2,2,4-trimethylpentane

p-xylene (1,4-dimethylbenzene)

methylcyclohexane

styrene (ethenylbenzene)

isobutene

 

1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Sections 1, 6, 8, and 10 – 26.

Note 1: This test method covers systems in which the impurities form with the major component a substantially ideal or sufficiently dilute solution, and also systems which deviate from the ideal laws, provided that, in the latter case, the lowering of the freezing point as a function of the concentration is known for each most probable impurity in the given substance.

Significance and Use

4.1 The experimental procedures and physical constants provided by this test method, when used in conjunction with Test Method D1015, allow the determination of the purity of the material under test. A knowledge of the purity of these hydrocarbons is often needed to help control their manufacture and to determine their suitability for use as reagent chemicals or for conversion to other chemical intermediates or finished products.

Keywords

crystallization; freeze point; LPG; pure hydrocarbons; purity;

To find similar documents by ASTM Volume:

05.01 (Petroleum Products and Lubricants (I): D56 - D3710)

To find similar documents by classification:

71.080.01 (Organic chemicals in general)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

 

Customers who bought this document also bought:

NAS-410
NAS Certification and Qualification of Nondestructive Test Personnel

MIL-H-7199
Heat Treatment of Wrought Copper-Beryllium Alloys, Process for (Copper Alloys: Numbers C17000, C17200, C17300, C17500, and C17510) (Superseded by SAE-AMS-H-7199)

DODISS-CD-ROM-SUBSCR
Department of Defense Index of Specifications and Standards - No Longer Available

Document Number

ASTM-D1016-05(2015)

Revision Level

2005 R15 EDITION

Status

Superseded

Modification Type

Withdrawn

Publication Date

June 1, 2015

Document Type

Test Method

Page Count

13 pages

Committee Number

D02.04.0D