ASTM-D1101 › Historical Revision Information
Standard Test Methods for Integrity of Adhesive Joints in Structural Laminated Wood Products for Exterior Use
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods cover an accelerated means of measuring the resistance to delamination of structural laminated wood members intended for exterior service.
1.2 Two test methods are included. Choice of test method depends on purpose of the test and available time to complete.
1.2.1 Test Method A- This test requires 3 days to complete and is a method for determining the suitability of glues and manufacturing techniques and equipment for production of joints adequate for exterior service.
1.2.2 Test Method B- This test requires approximately 12 1/2 h. (If excessive delamination occurs, the cycle is repeated). It is a quality-control type test for examining glue joint quality.
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
exterior use; glulam; laminated wood; structural-glued-laminated timber; structural laminated wood; ICS Number Code 83.180 (Adhesives)
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D1101-97a
Revision Level
1997A EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Nov. 10, 1997
Document Type
Test Method
Page Count
3 pages
Committee Number
D14.30