Document Center is acquired by Nimonik

1.1 This test method covers the determination of ash content after ignition of commercial engine coolants and antirusts, as packaged or after use.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific warning statements are given in 7.1 and 7.3.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

5.1 This test method is designed to aid in identifying types of coolants. While the ash is primarily due to the inorganic inhibitors used, it is not a measure of the total inhibitor concentration because of the loss of organic inhibitors.

5.2 An ash content greater than that stated in Specification D3306 may indicate a salt-based product.