ASTM-D1172 Standard Guide for pH of Aqueous Solutions of Soaps and Detergents

ASTM-D1172 - 2015 EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This guide details the standard procedures for the preparation of aqueous solutions of soaps and detergents and the determination of their pH. The required reagent for this procedure is distilled water or its equivalent, and the recommended electrodes for the determination of pH are the Fischer Accuphast combination electrode or Orion Ross Sure Flow electrode or their equivalents.

ORDER

Price:

$46.00        


Want this as a site license?

Changes from the previous issue

A redline edition is available for this document, with all changes visible. Ask Document Center Inc. for more information.

Scope

1.1 This guide covers the preparation of aqueous solutions of soaps and detergents and the determination of their pH.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Material Safety Data Sheets are available for reagents and materials. Review them for hazards prior to usage.

Keywords

ICS Number Code 71.100.40 (Surface active agents)

To find similar documents by ASTM Volume:

15.04 (Soaps and Other Detergents; Polishes; Leather; Resilient Floor Coverings)

To find similar documents by classification:

71.100.40 (Surface active agents)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

 

Customers who bought this document also bought:

ASTM-F1249
Standard Test Method for Water Vapor Transmission Rate Through Plastic Film and Sheeting Using a Modulated Infrared Sensor

ASTM-E169
Standard Practices for General Techniques of Ultraviolet-Visible Quantitative Analysis

ASTM-E387
Standard Test Method for Estimating Stray Radiant Power Ratio of Dispersive Spectrophotometers by the Opaque Filter Method

Document Number

ASTM-D1172-15

Revision Level

2015 EDITION

Status

Current

Modification Type

Revision

Publication Date

July 1, 2015

Document Type

Guide

Page Count

2 pages

Committee Number

D12.15