ASTM-D1304 › Standard Test Methods for Adhesives Relative to Their Use as Electrical Insulation
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods cover procedures for testing adhesives in liquid, highly viscous, solid, or set states, that are intended to be cured by electronic heating, or that are intended to provide electrical insulation, or that are intended for use in electrical apparatus.
1.2 The procedures appear in the following order: (1) Procedure for Testing Adhesives Before Use:
Section Power Factor and Dielectric Constant of Liquid Adhesives 7 Direct-Current Conductivity 8 Extract Conductivity 9 Acidity and Alkalinity 10 pH Value 11 Section Power Factor and Dielectric Constant of a Dried or Cured Adhesive Film 12 Dielectric Strength 13 Volume and Surface Resistivity 14 Arc Resistance 151.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use . For a specific hazard statement, see 8.2.
Keywords
Adhesives-electrical insulation; Arc resistance/resistivity; Conductance and conductivity (electrical); D-c conductivity; Electrical insulating adhesives; Power factor; Resistance and resistivity (electrical)-adhesives; Surface resistivity; adhesives (liquid/highly viscous/solid/set states) in electrical; insulation-selecting test methods,; Dielectric strength retention; adhesives (liquid/highly viscous/solid/setstates) in electrical; insulation-selecting test methods,; Volume resistivity; adhesives (liquid/highly viscous/solid/set states) in electrical; insulation-selecting test methods,;
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-A370Standard Test Methods and Definitions for Mechanical Testing of Steel Products
ASTM-A480
Standard Specification for General Requirements for Flat-Rolled Stainless and Heat-Resisting Steel Plate, Sheet, and Strip
ASME-Y14.5M
Dimensioning and Tolerancing (Correctly Numbered ASME-Y14.5)
Document Number
ASTM-D1304-99R20E01
Revision Level
1999 R20(E1) EDITION
Status
Current
Modification Type
Revision
Publication Date
Feb. 1, 2020
Document Type
Test Method
Page Count
4 pages
Committee Number
D14.80