ASTM-D1370 › Standard Test Method for Contact Compatibility Between Asphaltic Materials (Oliensis Test)
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
1.1 This test method provides a means for evaluating contact compatibility between asphaltic materials. It is generally used to determine compatibility between the saturant and coating used in the manufacture of prepared roofings. Coating and saturant will be referred to, but comparable asphaltic materials may be tested where this test procedure seems applicable.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
4.1 This test method assesses the degree to which asphalts interact with one another. It can indicate possible future problems, especially blistering, in a roofing product if incompatible asphalts are in contact in the product.
asphaltic materials; coating asphalt; compatibility; contact; oliensis test; saturant asphalt ;; ICS Number Code 91.100.50 (Binders. Sealing materials)
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
2012 R16 EDITION
Nov. 15, 2016