Document Center is acquired by Nimonik

Scope

1.1 These test methods cover procedures for the chemical analysis of white titanium dioxide pigments.

1.2 The analytical procedures appear in the following order:

Sections Preparation of Sample 4 Qualitative Analysis 5 and 6 Moisture 7 Total Titanium: Jones Reductor Method 8 to 12 Aluminum Reduction Method 13 to 17 Aluminum Oxide 18 to 22 Silica 23 to 29

1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.> A specific hazard statement is given in Section 19.

Keywords

Aluminum oxide (Al[inf]2[reset]O[inf]3[reset]) content; aluminum oxide in titanium dioxide (TiO[inf]2[reset]) pigments, test,; Aluminum reduction method; total titanium in white titanium pigments, by aluminum reduction method,; test,; Jones reductor; total titanium in white titanium pigments, by Jones reductor, test,; Pigments-titanium dioxide; Pigments-white; Qualitative analysis/measurement; Silica content; Titanium content; Titanium dioxide (TiO[inf]2[reset]); White pigments-general analysis; white titanium pigments, chemical analysis, test,; Total titanium; total titanium in white titanium pigments, by Jones reductor/aluminum; reduction method, test; ICS Number Code 87.060.10 (Pigments and extenders)

To find similar documents by ASTM Volume:

06.03 (Paint -- Pigments, Drying Oils, Polymers, Resins, Naval Stores, Cellulosic Esters, and Ink Vehicles)

To find similar documents by classification:

87.060.10 (Pigments and extenders)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.